Upon completion of a thorough mix, degassing may be required to minimize air entrapment or bubbles. This will help build confidence handling and working with our product. During that time, the small business owners realized that too many epoxy resins on the market were not up to snuff. The product will also get hot and possibly smoke. Example: 5 level spoonfuls of epoxy resin to 1 level Measuring and mixing epoxy resins accurately and safely is an essential skill for any resin user that wants to stay healthy and have great results with their project. Air Bubbles - Once the entire surface has been covered with a seal coat, the process of releasing/removing air bubbles may begin. (see below). Using some protective gear, like gloves, is recommended while working with the resin and hardener. This epoxy is specifically meant to execute a number of different professional and DIY projects. Do not fill or cast layers of epoxy thicker than 1/2"-thinner if enclosed by foam or other insulating material. Gorilla takes epoxy to the Gorilla tough level. Pro Marine is very specific on this second part—mixing the second time for more than five minutes can result in a hot, smoking resin. Measure 1-part RESIN to 1-part HARDENER by liquid volume (not weight). NOTE: Some people may be more sensitive to epoxy than others – and may wish to wear a ventilator when using the product. Revision: April 24, 2018 Supersedes: August 30, 2016 Ref. Pro Marine Supplies was then established in 2013 to fulfill the demand for much-needed Epoxy Resin products to suit the various needs of the Marine, Construction, and Art Industry. It can be poured up to 2 cm deep per layer. container (alternatively metal) when mixing Epiglass HT9000 Epoxy Resin and mix small amounts at any one time, to prevent heat build -up. Measuring - It is imperative that the product is measured as accurately as possible and mixed thoroughly. Use the flat end of the mixing stick to reach the inside corner of the pot. Air Bubbles - Once the entire surface has been covered with a flood coat, the process of releasing/removing air bubbles may begin. This popular handbook was the catalyst for the success of WEST SYSTEM epoxy. A versatile high performance polyamide cured epoxy designed to fulfi l the needs of both new construction and maintenance painting. To assure that you’re mixing epoxy thoroughly, scrape the sides and bottom of the pot as you mix. This also occurs during a deep pour. Pump 1 full pump stroke of resin for each, 1 full pump stroke of hardener. Data for individual products may vary and is subject to change. When pouring, fill the lowest part first. The time it takes for this transformation is the cure time. The marine epoxy revolution began with Gougeon Brothers in 1969. Mix the A/B system for at least 3 minutes, scraping along the sides and bottom of mixing vessel. A seal coat is a small batch of epoxy that is typically brushed on in a thin layer to seal a porous surface (hardwood, barn wood, knotty wood, etc.). Careful measuring of epoxy resin and hardener and thorough mixing are essential for a proper cure. To apply the flood coat, start on one end and pour the resin the entire length of the surface, zigzagging as you go. The mixing ratio is 1:1, and you have about 30 to 40 minutes of work time. Both sides must be exactly equal. Once we applied the epoxy to a surface, it felt like I had shards of glass cutting inside my All timber should be coated with at least two coats of Bote-Cote. If the product has been exposed to cold temperatures; acclimate by placing jugs in a warm water bath.